Instructions for Using Dry Transfer Letters


Dry transfer letters and numbers are ideal for labelling artwork, files, binders, reports, books, films, and negatives. It is possible to write on film, models, electrical devices (aiplanes, control panels, keyboards), appliances, and automobiles using dry transfer letters. Model ships, trains, buildings, and other things can be labelled and dry transferred with these hobby project supplies. Field Notes dry-transfer lettering is easy to apply with the provided instructions. You can find custom rub on decals for great prices easily. 

Think about letter spacing, line spacing, word length, and alignment when you write your headline on scrap paper and then estimate how it will fit in the space provided. 

Draw soft pencil lines around 7.5pt below the planned baseline for each row of text. To correctly align the text, utilise the lines printed under the letters on the transfer sheet. Create a vertical line in the middle of the notepad if you want to centre the headline. Calculate the word or phrase’s optical centre. Proceed with the leftover letters. Kerning must be done with care. Because different pairings of letters require varying amounts of kerning to appear best, the spacing between characters should be calculated aesthetically rather than mathematically.

Clean the area thoroughly and remove the adhesive protecting covering. Remove any mismatched letters or stray fragments of transfer with care.

This will most likely fall off. Make certain that the backside of the dry transfer letter does not become soiled. Place the dry transfer letter on the surface of the frame, taking care to get the exact position on the first try. You won’t be able to stick the dry transfer letter down and peel it off with any success. One approach is to utilise the previously removed adhesive protector sheet as a partially holder for the sticky side of the dry transfer letter.

Once in place, rub the burnishing protector sheet with your fingertips, beginning in the centre of the dried transfer letter and working your way out to the edges, being cautious not to trap air bubbles. 

Use a hard plastic applicator to rub or burnish the entire dry transfer letter. Your thumbnail will also work. Even with this additional burnishing, the end product may be susceptible to scratching, peeling, and wear with use. To further protect the lettering, you may choose to use a fixative spray or a clear coat. To ensure that the fixative does not damage the colour or texture of the paper or interfere with the glue on the dry-transfer lettering, test it in an inconspicuous area or on similar paper.

Peel off the burnishing sheet slowly. It ought to fall away. If it’s stuck to the dry transfer letter, rebunish that section of the sheet until it easily peels away. Tiny bubbles in the dry tranfer letter will pull themselves down in approximately a half-hour after it is affixed. Complete with a protectant, such as furniture polish or bike-specific frame polish. Transfer lettering dries out with time, making it more difficult to apply correctly.